UPSB v4
Tutorials Pending Approval / HGG MMT
-
Date: Sat, Dec 18 2010 21:14:27
HGG MMT Created By: Jan -------------------------------------------------------------------------------
With Anyball/Profile Grips
Without Anyball/Profile Grips
Statistics:
-----------------------------------------------------
[Name]:HGG MMT
[COG]: 3mm to the front (from the center)
[Length]: 20cm
[Weight]: RSVP MMTSpoiler [Preparing the Body] 1.) Take the HGG body and take out the ink tube and back plug. Afterward, sand the front part of the tube so there are no bumps.
2.) Sand the clip off of the HGG cap and take off the colored plastic part and the gummy circle inside so that there is a 3.5mm hole on the top.
3.) Put the finished cap on the back of the HGG body. The HGG tip should be on also.
[Preparing the Back Cap]
4.) Sand off the clip of the RSVP cap.
5.) If the cap has it, take the colored ball out of the cap. To do this, take a thin metal part (such as a screw or nail) and heat it using a lighter. Then poke a hole on the top of the cap. Now you can take out the ball.
6.) Take sections of the Profile/Anyball and put it on the cap
[Preparing the Front]
7.) Cut the G2 body on the line shown (there is also a line on the G2 barrel which i used as a reference).
8.) Put an Anyball/Profile grip on the body. You may have to stretch the grip on.
[Assembling the Mod]
9.) Take a 18.5 x 3.5cm insert and put it into the HGG cap and down into the body.
3-4cm should be sticking out.
10.) Put the RSVP cap onto the HGG cap about 1-2 cm.
11.) Slide the G2 barrel onto the front of the HGG body.
FINISHED :applaud:
[NOTE]: The original design didn't have Anyball/Profile grips. This makes it look more like a thin mod such as the RSVP MMT. When without Anyball/Profile grips, the back is heavier than the front by just a little bit.
Also, sorry for the bad quality
[FAQ]:
Q: The G2 body won't fit onto the HGG body.
A: Sand it down more. But make sure that in the beginning, you don't sand it down too much because then, it will slide off and there is no way of fixing this.
Q: The insert wont go inside the HGG cap.
A: Either make the insert less than 3.5cm width or poke a bigger hole in the top of the HGG cap
[Helpful Tips]
Don't slide the RSVP cap to far into the HGG cap because it will get stuck.
[Requested By:] JackyMacky -
Date: Sat, Dec 18 2010 21:28:01
This is just a RSVP MMT/NXMMT/whateveryouwannacallit variation. Subbing a part does not make it a new mod.
-
Date: Sat, Dec 18 2010 22:20:59
Just a heads up, this has been made long ago during UCPSBv1 with the Clear comssa method.
-
Date: Sat, Dec 18 2010 23:01:42
1 request. Awesome...
